Instruction
Place your MB on the ground on a place of drive in a way that player can control
passing of a cast through a twizzle of the interposer bar and controlling rod and to avoid a manipulation of another person. You activate your GMB by pressing shortly on the ON button. After “selftest” you can see on the screen the total number of drives which has been so far achieved, then the cast will be loosen with the chained ball.
Next step is to enable a ball from the container which is situated on the back site of the simulator. Enable the interposer bar and controlling rod off of the transport holder on the bottom side of the simulator. Input the triple-piece laminated telescope and the interposer bar with controlling rod to the slot into the lever and fix it in its maximum length in a way that the cast dangles in the twizzle of the interposer bar and controlling rod. Time of preparation shouldn’t take longer than 15 - 20 seconds. If you keep the parameters as they have been set in the factory, your simulator is ready to use.
The interposer bar and controlling rod are used to eliminate possible impact of braking and to ease the movement of returning ball through field obstructions but also after turning off the automatic coiling and the return of the ball even after its catch on the field obstruction. After freeing the ball from the obstruction by simple movement of the interposer bar to the left side, activate the reverse coiling to get the balls to requested position.
To eliminate unfitting cast position, use coloured laminated pin, which you find in the holder together with the interposer bar and controlling rod. Dig the pin min. 0,5 m between GMB and a pad in the drive direction. The cast is led around the pin, eventually is this pin simply laid on the cast just before the drive.
After you finish your game, pack the interposer bar and controlling rod and put them back to the transport 
holder and the ball to the container. By pressing and holding red OFF button you activate slow coiling of the rest of the cast. The simulator will wish you a nice day and then will be turned off.
You can place your simulator also on a broken topography by setting up the construction with hobs and screws with anchoring slot and with metal clinches (included in the package). Globe joint allows position arrest of the simulator box in approximate horizontal position (you can control with built-in level). These non stationary elements allow you to train your drives in various positions.
To extend your active season you can use the simulator in various climatic conditions – game to the water, on the sand, in the snow, etc. Professionals and club players can use GMB in the times when the terrain of the golf areas doesn’t allow any training or automatic balls gathering.
To avoid a pollution of the sensing device, use spatula at the end of the interposer bar and controlling rod.